how to use aircrack while on the internet

$ lspci | grep Wireless # PCI Based Wi-Fi Hardware In wireless networking, there are multiple modes that can be used to handle connections (managed mode) and monitor packets (monitor mode).Īll hardware doesn’t support monitor mode, so to check whether your hardware supports monitor mode, execute the below code on your terminal screen, and note down the chipset code. Monitor Mode allows a wireless router to view the contents of its connected devices on the same channel as it works. Note that while we are targeting a specific device with -c, it’s optional, and you can send this command to every device on the target network if needed.Windows 11 - How To Enable & Disable WIFI Network Adapter What is Monitor Mode? We have -a which is our BSSID, and -c is one of the devices that shows up under Station from the previous window. Here we’re using the aireplay-ng command (part of the aircrack suite) - deauth 0 is the command used to send deauthentication packets at the access point. To do this, we’ll use the following command:Īireplay-ng - deauth 0 -a 08:9E:08:EE:7D:68 -c 0E:9A:9O:C8:70:F1 wlan0mon Since most devices are set up to auto-reconnect to their known network, they’ll be forced into our coveted 4-way handshake. With our capture in place, our next step is to knock any devices off that target network. And once again, specifying our interface at the end.

Here we’re telling airodump to capture any data on this specific BSSID on this particular channel and write them to the file called dead_cap. To do that, we’ll use the following command:Īirodump-ng -c 6 -w dead_cap -d 08:9E:08:EE:7D:68 wlan0mon To get this 4-way handshake, we will use airodump-ng to capture packet exchanges between our AP and the other devices on the network.

With this handshake, a WPA/WPA2-pre-shared key is exchanged, which is what we are after. The 4-way handshake is the protocol used between the AP and the connecting device. What we don’t see here is a 4-way handshake. These stations are simply devices connected to that particular AP.

With airodump displaying the network traffic for Dead Zone 3.0, we notice at the bottom of the screen there are stations connected to the BSSID.

How to use aircrack while on the internet